ProLiant ML150 Server NOS - (English) Installation and Software Guide

Installing Microsoft Windows Server 2003 and Small Business Server 2003
Section 6. Installing the ZCR Driver
If an optional ZCR card is installed in your server, an appropriate driver is required
for the ZCR controller to operate properly. You can create the driver diskette from
the HP Startup CD-ROM for easy installation.
Creating the Driver Diskette
1. Insert one blank, formatted 3.5” diskette into the flexible diskette drive of a PC
running Microsoft Windows.
2. Insert the HP Startup CD-ROM into the CD-ROM drive of the above PC and
click HP ProLiant ML150 drivers on the Startup menu.
3. Select the proper driver to install.
4. Follow the on-screen instructions to create the driver diskette.
NOTE: If the PC does not auto-start the Startup menu, start it by opening startup.htm, found
at the root level of the Startup CD-ROM.
Performing the Installation
1. Boot the server from the Windows 2003 CD-ROM.
2. You will see a message that reads, Setup is inspecting your hardware
configuration. Then the setup screen will be displayed.
3. Always press the F6 key when the system briefly shows the message of Press F6
if you need to install a third party SCSI or RAID controller at the bottom of
the display.
NOTE: Unfortunately, Windows 2003 setup only gives you a short time to press the F6 key. If
you miss it, reboot the system and start from step 1 above.
a. Press the S key to specify additional SCSI adapters.
b. When prompted, insert the ZCR driver diskette you created from the Startup
CD-ROM.
HP ProLiant ML150 Server NOS Installation and Software Guide 3-11
HP CONFIDENTIAL
Writer: Pauline Tsai File Name: d-ch3 Installing Microsoft Windows Server 2003 and Small Business Server 2003.doc
Codename: Stone Soup Part Number: 343330-003 Last Saved On: 1/7/04 3:51 PM