ProLiant ML150 Server NOS - (English) Installation and Software Guide

Installing Microsoft Windows 2000 Server and Small Business Server 2000
3. Using a disk imaging utility to duplicate a hard drive will create a duplicate
signature.
At this time, Microsoft has no fix for this problem. For more information please refer
to Microsoft document ID: Q226361.
HP recommends that you use the following workaround for this problem.
1. If you experience this problem, remove all drives with the exception of the target
boot drive. Install Windows 2000 and then add the removed hard drives to the
system after installation of the OS.
2. Run the Disk Management tool to prepare the remainder of the drives to be used
in the system.
a. Boot the system with a Windows 98SE recovery diskette. (This version
supports FAT32, which works on larger hard drives.)
b. Perform an FDISK on each drive.
c. Install Windows 2000.
Tip #2. Configuring the Parallel (LPT) Port for ECP Mode
The device manager may not show this port on the list when not configured in ECP
mode.
HP recommends that you systematically configure the LPT port for ECP mode. Use
the following procedure to change the setting:
1. Press the Delete key during power on self-test.
2. Select Advanced > Super IO Configuration > Parallel Port Address to 378.
3. Press the Enter key and select ECP from Parallel Port Mode.
4. Press the Enter key and the F10 key to save and exit.
HP ProLiant ML150 Server NOS Installation and Software Guide 2-15
HP CONFIDENTIAL
Writer: Pauline Tsai File Name: c-ch2 Installing Microsoft Windows 2000 Server and Small Business Server 2000.doc
Codename: Stone Soup Part Number: 343330-003 Last Saved On: 1/7/04 3:49 PM