ProLiant ML150 Server NOS - (English) Installation and Software Guide

Installing SCO OpenServer 5.0.7
Section 5. Installing the ZCR Driver
If an optional ZCR card is installed in your server, an appropriate driver is required
for the ZCR controller to operate properly. You can create the driver diskette from
the HP Startup CD-ROM for easy installation.
Creating the Driver Diskette
1. Insert one blank, formatted 3.5” diskette into the flexible diskette drive of a PC
running Microsoft Windows.
2. Insert the HP Startup CD-ROM into the CD-ROM drive of the above PC and
click HP ProLiant ML150 drivers on the Startup menu.
3. Select the proper driver to install.
4. Follow the on-screen instructions to create the driver diskette.
NOTE: If the PC does not auto-start the Startup menu, start it by opening startup.htm, found
at the root level of the Startup CD-ROM.
Performing the Installation
1. Boot the server from the SCO OpenServer 5.0.7 Base Operating System
installation CD-ROM.
2. On the boot: prompt, type the link after the prompt as shown below:
Boot: defbootstr link=dpti5
3. When the Please insert the fd(65)dpti5 volume and press <Return>, or ‘q’ to
quit: message appears, insert the driver diskette into the flexible disk drive, and
press the Enter key.
4. After loading the ZCR driver, press the Enter key to start the installation.
Continue with the standard SCO OpenServer 5.0.7 installation as described in the
“Installing the Operating System” section earlier in this chapter.
12-8 HP ProLiant ML150 Server NOS Installation and Software Guide
HP CONFIDENTIAL
Writer: Pauline Tsai File Name: m-ch12 Installing SCO OpenServer 5.0.7.doc
Codename: Stone Soup Part Number: 343330-003 Last Saved On: 1/7/04 4:33 PM