DVD-ROM Drive Installation Instructions for HP ProLiant DL760 Generation 2 Servers

c. Pull the media module out of the chassis until it contacts the
module stop latches (1).
d. Press in the module stop latches and pull to completely
remove the module from the chassis (2).
2. Remove the media module bezel.
a. Remove the four screws that secure the bezel to the module
using a Torx T-15 screwdriver.
b. Lift up and pull the bezel away from chassis.
3. Remove the integrated diskette drive and CD-ROM drive tray.
a. Turn the media module over and disconnect the CD-ROM
drive signal cable (1), the diskette drive control and data
cable (2), and the diskette drive power cable (3) from the
back of the drives.
b. Remove the tray screw located on the front of the media
module (1).
c. Slide out the integrated diskette drive/CD-ROM tray (2).
4. Remove the CD-ROM drive from the tray.
a. Remove the front right screw using a Torx T-15
screwdriver (1).
b. Slide the CD-ROM drive back and up to remove it from
the tray (2).
c. Remove the remaining screws from the CD-ROM drive.
5. Install screws into the DVD-ROM drive. Use the three screws
removed from the CD-ROM drive.
6. Reverse steps 1 through 4b to install the DVD-ROM drive in
the media module.
The installation is complete.