Compaq Parallel Database Cluster Model PDC/O2000 for Oracle8i and Windows 2000 Administrator Guide

Cluster Management 6-13
Compaq Confidential – Need to Know Required
Writer: John Blackburn Project: Compaq Parallel Database Cluster Model PDC/O2000 for Oracle8i and Windows 2000 Administrator Guide Comments:
Part Number: 225082-002 File Name: g-ch6 Cluster Management.doc Last Saved On: 6/13/01 10:29 AM
6. After installing the new Ethernet OSDs, restart OracleCMService and
OracleNMService on all nodes.
7. Restart the Oracle instances on all nodes.
Deinstalling a Partial OSD Installation
While not a common occurrence, the Oracle Universal Installer might not be
able to complete the installation of the Compaq Ethernet OSDs. An incomplete
OSD installation could result for various reasons, for example:
■ A client LAN cable is no longer seated tightly into its connector.
■ The node from which you are running the OUI cannot communicate
with all other nodes in the cluster.
■ The user running the OUI does not have administrator privileges on all
cluster nodes.
An incomplete installation can result in a partial installation of the OSDs on
the cluster. If this occurs, you must clean up after the partial installation (by
removing it) before you can successfully run the Oracle Universal Installer
again.
To remove a partial OSD installation:
1. Insert the Compaq Parallel Database Cluster Clustering Software for
Oracle8i on Microsoft Windows 2000 CD into the CD-ROM drive of a
cluster node.
2. From a command prompt, navigate to the CD-ROM drive.
3. Connect to the \Utilities directory.
4. Run the uninstall utility by entering:
uninstallOSD
5. Restart the node.
6. Repeat steps 1 through 5 on all other nodes in the PDC/O2000 cluster.