HP ProLiant DL385 Generation 5 Server Maintenance and Service Guide

Removal and replacement procedures 46

Remove the processor fan bracket plate.

To replace the component, reverse the removal procedure.

Media drive ejector assembly

To remove the component:

1. Power down the server (on page 28).

2. Extend or remove the server from the rack ("Extend the server from the rack" on page 27, "Remove

the server from the rack" on page 29).

3. Remove the access panel ("Access panel" on page 30).

4. Remove the air baffle ("Air baffle" on page 40).

IMPORTANT: For this procedure, you do not need to remove the hot-plug fans from the

processor fan bracket. When reinstalling the processor fan bracket, press the top of each fan

to be sure it seats securely.

5. Remove the processor fan bracket ("Processor fan bracket" on page 41).

6. Remove the media drive ("Media drive or blank" on page 35).

7. Remove the fan board ("Fan board" on page 44).