HP ProLiant DL385 Generation 2 Server Maintenance and Service Guide

Removal and replacement procedures 49
5.
Remove the PPM.
IMPORTANT: PPM slots must be populated when processors are installed. If PPM slots are not
populated, the server halts during POST or does not boot.
To replace the component, reverse the removal procedure.
PPM retainer
To remove the component:
1. Power down the server (on page 29).
2. Extend the server from the rack (on page 28).
3. Remove the access panel ("Access panel" on page 31).
4. Remove the air baffle ("Air baffle" on page 41).
5. Remove the PPMs ("PPM" on page 48).