ProLiant DL 380 Maintenance and Service Guide

Removal and Replacement Procedures 2-13
Power Supply Blank
To remove a power supply blank:
1. Push in the tabs on the power supply blank .
2. Pull the tab out until it is horizontal .
3. Pull the power supply blank out the back of the chassis .
IMPORTANT: A ProLiant DL380 Server ships standard with a single power supply module. The primary
module must populate the outer bay. A power supply blank may populate the inner bay. The blank can be
removed and a second power supply can be installed for redundant power supply capability.
3
1
2
Figure 2-7. Removing the power supply blank
Reverse steps 1 through 3 to replace a power supply blank.