ProLiant DL 380 Maintenance and Service Guide
Index 7
No configuration for accelerator
board 3-41
Nonfunctioning Voltage
Regulator Module 3-10
NVRAM configuration present,
controller not detected 3-41
Parallel Port X Address
Assignment Conflict 3-11
PCI slots powered down. 3-12
Permanently disabled 3-35
Power Fault On Processor
Bus X 3-10
Power Supply Failure, Power
Supply Unplugged, or Power
Supply Fan Failure 3-12
Primary Disk Port Address
Assignment Conflict 3-16
Primary Fixed Disk Port
Assignment Conflict 3-16
Primary power supply
failure 3-12
Processor Configuration
Invalid 3-9
Processor Power Module has lost
Redundancy 3-10
Processor PPM Failed 3-9
Processor PPM has lost
Redundancy 3-10
RESUME - F1 key 3-22
RIS copies between drives do not
match 3-41
ROM Error 3-8
Run System Configuration
Utility 3-22
SCSI cable error detected 3-12
SCSI Port X Drive ID X
failed - Replace 3-42
firmware needs
upgrading 3-42
has exceeded
threshold(s) 3-41
has loose cable 3-42
is not stamped for
monitoring 3-41
replaced on a good
volume 3-42
RIS copy mismatch 3-41
SCSI Port X drive ID Y firmware
needs upgrading 3-42
Secondary Disk Port Address
Assignment Conflict 3-16
Set configuration command
issued 3-42
Slot X Drive Array
Array Accelerator Memory
Size Change
Detected 3-13
Capacity Expansion Process
is temporarily
disabled 3-15
Drive(s) disabled due to
failure during
expand 3-15
New Logical Drive(s)
Attachment
Detected 3-14
Obsolete data found in Array
Accelerator 3-16
Physical Drive Position
Change(s)
Detected 3-13
ProLiant Storage System
Not Responding SCSI
port (y) 3-16
Resuming logical drive
expansion process 3-15
SMART Drive Detects
Imminent Failure 3-13
Slot x Drive Array Controller
Failure 3-18
Slot x Drive Array Option ROM
is Not Programmed
Correctly 3-15
Snoop Rules SRAM
Failure 3-10
Soft Firmware Upgrade
required 3-42
System Board Failure 3-8
System Options Not Set 3-8
System Processor Failed/
Mapped out 3-9
Tag Update Rules SRAM
Failure 3-10
Temperature violation
detected 3-11
Time & Date Not Set 3-8
Unable to communicate with
drive on SCSI Port x 3-42
Unknown disable code 3-42
Unrecoverable read error 3-43
Unsupported Processor Detected
System Halted 3-8
Voltage Regulator Module for
Processor X 3-10
Warning bit detected 3-43
Warning, Drive Write Cache
enabled on X 3-43
Write memory error 3-43
Wrong Accelerator 3-43
Ethernet port, identified 4-2