ProLiant DL 380 Maintenance and Service Guide

6 Compaq ProLiant DL380 Maintenance and Service Guide
is a replacement drive
marked OK 3-38
is failed 3-38
is undergoing drive
recovery 3-38
needs replacing 3-38
upload code not
readable 3-38
was inadvertently
replaced 3-38
drive array
Array Accelerator Battery
Charge Low 3-21
Array Accelerator Battery
Depleted 3-21
Array Accelerator
Configuration
Error 3-22
Array Accelerator Not
Responding 3-22
Array Accelerator Read
Error 3-22
Array Accelerator Write
Error 3-22
Controller detects
replacement drives 3-17
Drive Failure 3-18
Drive(s) Disabled due to
Array Accelerator Data
Loss 3-22
External Drive Subsystem
Error 3-17
not Configured 3-18
Operating in Interim
Recovery Mode 3-19
Recovery Needed 3-19
Reports Valid Data 3-21
resuming Automatic Data
Recovery process 3-17
Drive Monitoring features are
unobtainable 3-38
Drive Monitoring is NOT
enabled 3-38
Drive Not Responding 3-21
Drive time-out occurred on
physical drive bay X 3-38
Drive X indicates
position Y 3-38
Duplicate write memory
error 3-39
Error occurred reading RIS copy
from SCSI Port X 3-39
Fan controller not
responding 3-12
Fan failure detected 3-11
Fatal ROM Error 3-8
Fixed Disk 0 does not support
DMA Mode 3-14
Fixed Disk does not support
Block Mode 3-14
Fixed Disk failed Identify
command 3-14
Fixed Disk failed Set Block
Mode command 3-14
FYI, Drive (bay) X is
non-Compaq supplied 3-39
I/O Fan (Fan X) failure
detected 3-11
I/O Fan controller not
responding 3-12
I/O ROM Error 3-8
Identify controller data did not
match NVRAM 3-39
Identify logical drive data did not
match NVRAM 3-39
Incorrect Drive Replaced 3-20
Insufficient adapter
resources 3-39
Internal SCSI Jumper Board Not
Installed 3-12
Invalid Memory
Configuration 3-9
Invalid Memory Speed 3-9
Keyboard Controller Error 3-11
Keyboard Error 3-10
Keyboard or System Unit
Error 3-11
Less than 75% batteries at
sufficient voltage 3-39
Locked SCSI Bus
Detected. 3-12
Log Reinitialized 3-9
Logical drive X failed due to
cache error 3-39
Logical drive X status
Failed 3-40
Interim Recovery 3-40
Loose Cable Detected 3-40
Needs Recover 3-40
Overheated 3-40
Overheating 3-40
Recovering 3-40
Wrong Drive
Replaced 3-40
Loose cable detected, logical
drives may be marked
FAILED 3-41
Low System Battery 3-12
Memory Address Error 3-9
Memory Detection Failure 3-9
Memory Error 3-9
Mirror data miscompared 3-41