ProLiant DL 380 Maintenance and Service Guide
Index 5
Fail-Safe Timer
Expiration 3-62
PCI Bus Parity Error 3-62
Processor Parity Error 3-62
Software Generated
Interrupt Detected
Error 3-62
Processor Exception 3-62
Processor Prefailure 3-62
Required System Fan
Failure 3-62
Server Manager Failure 3-62
UPS A/C Line Failure Shutdown
or Battery Low 3-62
error messages
A Critical Error occurred prior to
this power-up 3-8
Accelerator board not
detected 3-34
Accelerator error log 3-34
Accelerator parity read 3-34
Accelerator parity write 3-34
accelerator status
Cache was automatically
configured 3-34
Data in the cache was
lost 3-34
Dirty data detected has
reached limit 3-34
Dirty data detected. Unable
to write 3-34
Excessive ECC errors 3-35
Obsolete data detected 3-35
Obsolete data was
discarded 3-35
Obsolete data was
flushed 3-35
Possible data loss in
cache 3-35
Temporarily disabled 3-35
Unrecognized status 3-35
Valid data found at
reset 3-35
Warranty alert 3-35
Adapter/NVRAM ID
mismatch 3-36
Array accelerator battery pack X
not fully charged 3-36
Array accelerator battery pack X
below reference
voltage 3-36
ASR-2 Timer Failure 3-8
beeps only 3-22
Board in use by expand
operation 3-36
Board not attached 3-36
Cache Accelerator Slot X
Initialization Failed 3-10
Cache Accelerators Not
Installed 3-10
Cache Switch Set
Incorrectly 3-9
Com Port Address Assignment
Conflict 3-11
Configuration Nonvolatile
Memory Invalid 3-8
Configuration Not
Complete 3-8
Configuration signature is
zero 3-36
configuration signature
mismatch 3-36
controller
communication failure
occurred 3-36
detected. NVRAM
configuration not
present 3-36
firmware needs
upgrading 3-36
is not configured 3-37
located in special graphics
slot 3-37
reported POST error 3-37
restarted with a signature of
zero 3-37
CPU Fan (Fan X) failure
detected 3-12
CPU Fan controller not
responding 3-12
Current SCSI bus cable
configuration is not
recommended 3-12
DC-DC Converter Failed 3-9
Disable command issued 3-37
Disk 0 Configuration Error 3-21
Disk 0 Failure 3-17
Disk 1 Error 3-21
Disk 1 Failure 3-18
Disk Controller Failure 3-18
Diskette Controller Error 3-11
Diskette Drive Type Error 3-11
drive (bay) X
firmware needs
upgrading 3-37
has insufficient capacity for
its configuration 3-37
has invalid M&P
stamp 3-37
has loose cable 3-37
is a replacement drive 3-38