Compaq ProLiant DL380 Setup and Installation Guide

2-18

Compaq Confidential – Need to Know Required

Writer:

Gilbert Saldivar

Project:

Compaq ProLiant DL380 Setup and Installation Guide

Comments:

Part Number:

120133-002

File Name:

c-ch02 Server Installation Overview.doc

Last Saved On:

12/10/99 1:04 PM

Figure 2-10. Measuring with the template

After marking the front of the rack, open the rear door of the rack, flip

the template over, and mark the back rails of the rack.

On the back of the rack, mark the rail to show the top of the template.

This action will help you align the template for the next component.

Inserting Cage Nuts in the Rack Frame

After marking the positions for the fasteners in both the front and back of the

rack, use the fitting tool to insert cage nuts on the inside of the rails at the

marked locations. The cage nuts and fitting tool are included in the hardware

kit supplied with the rack.

Position the cage nut as shown in the following figure, on the inside of

the rail.

Hook one of the lips of the cage nut through the square rail perforation.

Insert the tip of the fitting tool through the other side of the perforation

and hook the opposite lip of the cage nut.