Compaq ProLiant DL380 Setup and Installation Guide
Server Configuration and Utilities
6-15
Compaq Confidential – Need to Know Required
Writer:
Gilbert Saldivar
Project:
Compaq ProLiant DL380 Setup and Installation Guide
Comments:
Part Number:
120133-002
File Name:
g-ch06 Server Configuration and Utilities.doc
Last Saved On:
12/10/99 1:14 PM
IBM OS/2 Device Drivers from Compaq
If you are using the Compaq NC3163 Fast Ethernet NIC
Embedded 10/100 WOL in a ProLiant DL380 server and you do not plan to
use the SmartStart installation process to setup your server, you must install
updated support software for your controller to connect properly to the
network.
Your server must have certain device drivers for some server options to
operate using IBM OS/2 Warp Server 4.0, IBM OS/2 Warp Server Advanced
4.0, IBM OS/2 Warp Server Advanced 4.0 with SMP, IBM OS/2 Warp 3.0
Connect, and IBM OS/2 Warp 4.0. These drivers are located on the Compaq
SmartStart and Support Software CD you received with your server. If you use
Compaq SmartStart to install your operating system, these drivers are loaded
automatically.
Otherwise, you can use Compaq SmartStart to create IBM OS/2 Support
Software Diskettes (SSD) from Compaq to support a manual installation or
retail software installation of IBM OS/2. The installation diskettes can be
customized for OS installation on Compaq servers by using the CPQSETUP
utility on the IBM OS/2 SSD.
For more information on these drivers, run the VIEWME.EXE file in the root
directory of the IBM OS/2 SSD Diskette 1 from Compaq.
Compaq SmartStart Installation
If you use Compaq SmartStart to install the OS, the drivers are installed
automatically.
Manual installation
If you choose not to let Compaq SmartStart configure the server, follow this
procedure:
1.
Insert the Compaq SmartStart and Support Software CD into the drive.
2.
Boot your system.
3.
Select Manual Installation.
4.
Follow the instructions that display on the monitor.
5.
If you have already created the SSD diskettes as part of your Manual
Installation process, skip to Step 9.