Compaq ProLiant Clusters for SCO UnixWare 7 U/300 Quick Install Guide for the Compaq ProLiant DL380

3-4 Compaq ProLiant Clusters for SCO UnixWare 7 U/300 Quick Install Guide for the Compaq ProLiant DL380
Compaq Confidential – Need to Know Required
Writer: Rachel Williams Project: Compaq ProLiant Clusters for SCO UnixWare 7 U/300 Quick Install Guide for the Compaq ProLiant DL380
Comments: Part Number: 221544-001 File Name: d-ch3 Installing Software.doc Last Saved On: 12/27/00 10:59 AM
4. Click Yes when prompted to continue. Wait for the configuration to be
erased.
5. If you used the Server Profile Diskette, remove it. Power down the
RA4100 if you are erasing the configuration on node 1. When prompted,
power down, and then power up only the server.
IMPORTANT: Do not turn the RA4100 back on at this time.
Continue with the following procedure for server configuration. Begin with
step 2 because you have erased a previous configuration.
Configuring the Servers
To configure the nodes using SmartStart:
IMPORTANT: The RA4100 must not be powered up during this procedure. Do not
configure any RA4100 logical disks prior to software installation; an RA4100 logical disk
is automatically configured by the Quick Install procedure.
1. If you did not erase a configuration, power up the server, and then insert
the SmartStart CD into the CD-ROM drive for node 1. If you erased a
configuration according to the preceding steps, begin with step 2.
2. Select the language at the prompt. The Regional Settings screen displays.
3. Select the country and keyboard type from the Regional Settings screen.
4. Set the date, time, and daylight savings time adjustment if applicable.
5. Click Next, and then click Continue. The License Agreement displays.
6. Accept the License Agreement to continue. An Installation Path window
displays.
7. Select Manual Configuration, and then click Begin.
8. Click the plus sign (+) preceding the SCO entry in the menu. A list of
operating systems displays.
9. Select SCO UnixWare 7.1.1, and then click Next. A warning screen displays.
10. Click Continue. Wait while the system configuration loads.
11. Use the arrow keys to select Review or modify hardware settings, and press
Enter. The
Steps in configuring your computer window displays.
12. Use the arrow keys to select Step 3: View or edit details, and then press
Enter.