Compaq ProLiant Clusters for SCO UnixWare 7 U/300 Quick Install Guide for the Compaq ProLiant DL380

3-2 Compaq ProLiant Clusters for SCO UnixWare 7 U/300 Quick Install Guide for the Compaq ProLiant DL380
Compaq Confidential – Need to Know Required
Writer: Rachel Williams Project: Compaq ProLiant Clusters for SCO UnixWare 7 U/300 Quick Install Guide for the Compaq ProLiant DL380
Comments: Part Number: 221544-001 File Name: d-ch3 Installing Software.doc Last Saved On: 12/27/00 10:59 AM
Understanding Preinstallation Tasks and
Considerations
Before you begin the software installation, assemble the hardware for the
cluster, fill out the Quick Install planning worksheets in Appendix B of this
guide, and have four formatted diskettes on hand. Read through this chapter to
become familiar with the installation procedures as you fill out the worksheets.
Default Quick Install Settings
Table 3-1 lists the default settings used during the Quick Install installation
procedure. These parameters can be modified after the installation is complete
by running the International Settings Manager in the System folder of the
SCOadmin system administration tool.
Table 3-1
Quick Install Default Settings
Parameter Default
Locale C Standard
Keyboard United States C
Code set C
Time zone Configurable to any U.S. time zone
Internal Disk Drive Considerations
Before you begin any procedures in this chapter, do not have any disk drives
in the internal storage area other than the one 9.1-GB or larger disk drive. The
Quick Install procedures require that only one disk drive reside in each server
during the installation.