HP ProLiant Storage Server User Guide (440584-003, September 2007)

• For the Telnet service to be started manually on every reboot, in the Startup Type drop-down

box, click Manual, and then click OK.

On the storage server, access the command line interface, either by Remote Desktop or a direct

connection, and then enter the following command:

net start tlntsvr

Sessions information

Thesessionsscreenprovidestheabilitytovieworterminateactivesessions.

Using the Integrated Lights-Out 2 method

Integrated Lights-Out 2 (iLO 2) i s HP's fourth genera tion of Lights-Out ma nagem ent technology that

allows you to perform virtually any system administrator or maintenance task remotely as if you were

using its keyboard; mouse; mo n itor; power button; and ﬂoppy, CD or USB key, whether or not the

server is operating. It is available in two forms, iLO 2 Standard and iLO 2 Advanced. iLO 2 Standard

provides basic system board management functions, diagnostics and essential Lights-Out functionality on

supported ProLiant servers. iLO 2 Advanced provides advanced remote administration functionality as a

licensed option, which is included with the ProLiant Storag e Server.

TheIntegratedLights-Outportonthestorageservercanbeconﬁgured through the Rapid Startup Wizard

or through the iLO 2 ROM-Based Setup Utility (RBSU) . SNMP is enabled and the Insight Management

Agents are preinstalled.

The HP iLO 2 management processor provides multiple ways to conﬁgure, update, operate, and m anage

servers remotely. The HP ProLiant Storage Server comes preconﬁgured with iLO 2 default factory settings,

including a default user account a nd password. These settings can be found on the iLO 2 Default

Network Settings tag found on the front of the ser ver. If iLO 2 is connected to a network running DNS

and DHCP, you can use it immediately without changing any settings.

For more information on using HP iLO 2, see the HP Integrated Lights-Out 2 User Guide.

To quickly set up iLO 2 using the default settings for iLO 2 Standard and iLO 2 Advanced features,

follow the steps below

1. Ensure that a net work c able is connected to the iLO 2 port located on the back of the storage server.

NOTE:

This con nection method is easiest when the connection is to a DHCP and DNS supported

network.

2. If you are not using dynamic DHCP (IP addressing), you will need to input a static IP address by

using the direct attach method and the iLO 2 RBSU.

3. Using the m ethods described in the HP Integrated Lights–Out 2 User Guide, connect to the iLO 2 port.

NOTE:

To ﬁnd the default iLO 2 log on settings, see the iLO 2 Default Network Settings card

attached to your server. The default DNS, administrator name, and password needed to

logonwillbeonthiscard.

4. If desired, you can change the default user name and password on the administrator account to

your predeﬁned selections.

5. Set u

p your user accounts, if using the local accounts feature.

6. Act

ivate iLO 2 advanced features by entering a license key from the included ProLiant E ssentials

Integrated Lights-Out 2 Advanced Pack.

Installing and conﬁguring the server