Compaq ProLiant DL380 Generation 2 Setup and Installation Guide

3-26 Compaq ProLiant DL380 Generation 2 Server Setup and Installation Guide

Compaq Confidential – Need to Know Required

Writer: Rob Weaver Project: Compaq ProLiant DL380 Generation 2 Server Setup and Installation Guide Comments:

Part Number: 203844-001 File Name: d-ch3 Installing Hardware Options.doc Last Saved On: 4/5/01 1:55 PM

Removing Hot-Plug SCSI Hard Drives

To remove hot-plug SCSI hard drives:

1. Back up all server data on the hard drive.

CAUTION: Before removing a hot-plug hard drive, determine the status of the

drive through the LEDs. See the “Hot-Plug SCSI Hard Drive LEDs” section in

Appendix E, “LED Indicators and Switches.”

IMPORTANT: If you are replacing a drive that is part of an array, refer to the “Hot-Plug

SCSI Hard Drive Replacement Guidelines” section in the Compaq Servers Troubleshooting

Guide.

2. Press the ejector lever release button .

3. Pull the ejector lever open .

4. Remove the hard drive .

Figure 3-22. Removing a hot-plug SCSI hard drive