Compaq ProLiant DL380 Generation 2 Setup and Installation Guide

PCI Hot Plug Technology 8-13
Compaq Confidential – Need to Know Required
Writer: Rob Weaver Project: Compaq ProLiant DL380 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 203844-001 File Name: i-ch8 PCI Hot Plug Technology.doc Last Saved On: 4/2/01 3:23 PM
Replacing an Expansion Board
To replace an expansion board:
1. In the PCI Hot Plug Utility, turn off the power to the required slot by
selecting it and clicking the power button.
2. Remove the existing expansion board:
a. Disconnect cables, if necessary.
b. Open the slot release lever.
c. Remove the expansion board from the slot.
3. Install the new expansion board:
a. Install the new expansion board in the slot.
b. Attach the appropriate cables.
c. Close the expansion slot lever.
4. In the PCI Hot Plug Utility, turn on the power to the slot by selecting it
and clicking the power button.
Compaq PCI Hot Plug Utility Messages
Compaq PCI Hot Plug Utility uses the following messages to indicate status of
the PCI Hot Plug system:
The requested machine is not running the Compaq Remote Control service.
You cannot connect to the specified machine because it is not running the
Compaq Remote Control service.
You don't have an account on the requested machine. You cannot connect to
the specified server because you do not have an account on it.
This machine does not have any PCI Hot Plug slots. The machine is running the
service but there are no PCI Hot Plug slots to view.
The service on the machine has shut down or has become unavailable. The
service on the machine you are viewing has shut down or has become
unavailable.