Ultra-Dense Server Deployment in Third-Party Racks

Compaq Ultra-Dense Server Deployment in Telecommunications (Telco) Racks 4
12CZ-0400A-WWEN
Following the guidelines in this document will minimize planning and installation time; however,
do not use this document as your sole source of information for the rack installation. Other rack
installation references include:
• Compaq Telco Rack Option Kit installation guide (poster included with each kit).
• “Compaq Ultra-Dense Server Deployment Solutions Overview,” Compaq Document
Number 1237-0300A-WWEN, white paper available at
http://www.compaq.com/support/techpubs/whitepapers/index.html
• Compaq Rack Builder Pro 2.5 or later, design and planning software utility, available for
download from the Compaq website at
http://www.compaq.com
Detailed information specific to a product described in this document can be found in the
corresponding product manuals.
Rack Warnings
This document should be used only as an information source for planning your deployment.
Avoid personal injury and equipment damage by following accepted safety practices.
WARNING: Ensure proper floor support. Ultra-dense Compaq ProLiant DL360 server
deployments, related equipment and cables may exceed 1,800 pounds.
WARNING: Be aware of the center of gravity and tip hazard. Compaq recommends that the
footings extend 10 inches from the front and back of any Compaq rack 22U or higher. Adequate
stabilization measures are required. Ensure that the entire rack assembly is properly secured and
that all personnel are trained in proper maintenance and operation procedures. Tip hazards
include personal injury and death.
WARNING: Ensure your installation has adequate power supply and branch circuit protection.
CAUTION: Thermal dissipation requirements of an ultra-dense Compaq ProLiant DL360 server
deployment mandate 3 inch minimum unrestricted airspace to the front and the rear of each
server.