ProLiant DL360 Server Maintenance and Service Guide

Diagnostics and Troubleshooting
Compaq ProLiant DL360 Server Maintenance and Service Guide 4-63
COMPAQ CONFIDENTIAL Codename: MIcroMachines Part Number: 169616-006 Last Saved On: 12/21/01 9:05 AM
Table 4-19: Compaq System Configuration Utility Paper Settings for Booting into
Compaq Utilities
continued
Pager Data Example
Setting
Description
Dial-out status Enabled Allows ASR-2 to dial out to a remote workstation. If you
selected this option, Dial-In Status is automatically selected.
To use the dial-out feature, set Dial-Out Status to Enabled
and set the Dial-Out String to the correct phone number. You
must also set the Reset Boot option to Boot Compaq
Utilities. When the system restarts because of an ASR reset,
the administrator is paged via Pager Status and Pager Dial
String, the system restarts to the Compaq Utilities, and dials
out to the phone number provided in the Dial-Out string. The
dial-out number will be tried five times. If it fails to connect
after five attempts, the modem is put in autoanswer mode.
Dial-out string 555-1234 Enter the dial string followed by the remote computer
telephone number.
Network status Enabled
To allow network access to Compaq Utilities, set Network
Status to Enabled and ensure that the Reset Boot option is
set to Boot Compaq Utilities.
Network
protocol
To use IPX network access, set Network Protocol to IPX.
When the system restarts to the Compaq Utilities because of
an ASR reset, it loads IPX network support. This enables
remote access using NVT.
To use IP network access, set Network protocol to IP. Also
make sure to set Network IP address, Network IP net mask,
and Network IP router address. When the system restarts to
the Compaq Utilities because of an ASR reset, it loads IP
network support. This enables remote access using Telnet.
Note: The Network Status must be set to Enabled for
network access.
Network
controller
Compaq For all Compaq standard network controllers.
Network host
name
CPQHOU Enter the network name of the server. Use underscores
instead of spaces within the name—for example,
Compaq_Server. If you are using IPX network access to the
Compaq Utilities, this server name is used to advertise NVT
host services. This server name displays in the Compaq
Insight Manager server list when the program determines it
can communicate using NVT. Set this name to be the same
as the server name you assign when the host OS is running.
Network card
slot
Slot # Select the slot number of the network interface card you wish
to use for network access to Compaq Utilities.
Network frame
type
ETHERNET_I I Select the frame type for the network. Selections include both
Ethernet and Token Ring topologies.
continued