Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide

Installing Hardware Options 3-25
Compaq Confidential – Need to Know Required
Writer: Ed Giblin Project: Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 233832-001 File Name: d-ch3 Installing Hardware Options.doc Last Saved On: 8/31/01 11:44 AM
Figure 3-19. The PCI riser board assembly removed from the chassis
Installing an Expansion Board
CAUTION: Do not operate the server unless an expansion board or expansion
slot cover is installed in each slot. Failure to do so results in improper cooling
that can lead to thermal damage.
To install an expansion board:
1. Power down the server. See “Powering Down the Server” earlier in this
chapter.
2. Remove the server from the rack. See “Removing the Server from the
Rack” earlier in this chapter.
3. Remove the access panel. See “Removing the Access Panel” earlier in
this chapter.
4. Remove the PCI riser board assembly. See “Removing the PCI Riser
Board Assembly” earlier in this chapter.