Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide

Installing Hardware Options 3-23
Compaq Confidential – Need to Know Required
Writer: Ed Giblin Project: Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 233832-001 File Name: d-ch3 Installing Hardware Options.doc Last Saved On: 8/31/01 11:44 AM
Table 3-4
Expansion Slot Locations
continued
Location Slot
Slot 2 – 64-bit/3.3V slot with 528-MB/s data
transfer
System board connector
Removing the PCI Riser Board Assembly
To install expansion boards, remove the PCI riser board assembly from the
chassis. Expansion boards are inserted into the riser board before the assembly
is reinserted into the chassis.
To remove the riser board assembly:
CAUTION: To avoid the risk of damage to the system or expansion boards,
remove all AC power cords before installing or removing expansion boards.
When the Power On/Standby switch is in the Standby position, auxiliary power is
still connected to the PCI expansion slot and may damage the card.
1. Power down the server. See “Powering Down the Server” earlier in this
chapter.
2. Remove the server from the rack. See “Removing the Server from the
Rack” earlier in this chapter.
3. Remove the access panel. See “Removing the Access Panel” earlier in
this chapter.
4. Disconnect any cables leading from any current expansion boards to the
system board.
5. Open the expansion board retaining lever.