Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide

Installing Hardware Options 3-9
Compaq Confidential – Need to Know Required
Writer: Ed Giblin Project: Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 233832-001 File Name: d-ch3 Installing Hardware Options.doc Last Saved On: 8/31/01 11:44 AM
Removing the Access Panel
To remove the access panel:
1. If the server is operating, power down the server. See “Powering Down
the Server” earlier in this chapter.
2. If the server is installed in a rack, remove the server from the rack. See
the preceding section, “Removing the Server from the Rack.”
NOTE: If the rack management solution option (slide rails and a cable management
system) is installed, many hardware procedures may be performed without removing the
server from the rack. For more information, see “Optional Rack Deployment Solutions” in
Chapter 1, “Server Features.”
3. Press and hold down the hood latches .
4. Holding the latches down, slide the access panel toward the rear of the
unit about 0.5 inch (1.25 cm) and lift the panel to remove it
.
1
2
1
Figure 3-6. Pressing the hood latches and removing the access panel