Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide

3-2 Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Ed Giblin Project: Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 233832-001 File Name: d-ch3 Installing Hardware Options.doc Last Saved On: 8/31/01 11:44 AM
CAUTION: Always ensure that equipment is properly grounded before beginning
any installation procedure. Electrostatic discharge resulting from improper
grounding can damage electronic components. For more information, refer to
Appendix B, “Electrostatic Discharge.”
Hardware Option Procedures
This chapter includes step-by-step instructions for the following items:
■ Preparing the server
GPowering down the server
GRemoving the server from the rack
GRemoving the access panel
GInstalling the access panel
GIdentifying system board components
■ Upgrading a processor
GRemoving a processor
GInstalling a new processor and PPM
■ Installing DIMMs
■ Installing an expansion board
GIdentifying expansion slots
GRemoving the PCI riser board assembly
GInstalling an expansion board
■ Removing the CD-ROM drive
■ Installing the CD-ROM drive
■ Removing a floppy disk drive
■ Installing a floppy disk drive
■ Removing hot-plug SCSI hard drive blanks
■ Installing hot-plug Wide Ultra3 SCSI hard drives