Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide

Index 5
Compaq Confidential – Need to Know Required
Writer: Ed Giblin Project: Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 233832-001 File Name: r-index.doc Last Saved On: 10/12/01 3:25 PM
server will not start 10-1
ethernet, full-duplex 1-5
European union notice A-4
event list, IML 9-3
event messages log 9-3
expansion board retaining
lever 3-23, 3-30
expansion boards
installation 3-25
expansion slots
32-bit 3-23
64-bit 3-22
features 1-4
locations 3-22, 4-11
extending the server from the
rack 4-16
external cabling 7-3–7-7
F
failure condition recovery,
ROMPaq disaster recovery D-4
fan assembly
connector, location 3-12
minimum configuration 10-2
FCC See Federal Communications
Commission (FCC)
features 6-2
Federal Communications
Commission (FCC)
compliance notice
Class A A-2
Class B A-2
declaration of conformity A-3
notice A-1
requirements A-3
rules A-2, A-3
firmware
updating 6-3
floppy interface 1-6
frequency, rated input F-1
front panel
LEDs See also LEDs
front-side bus, speed 1-3
FTP sites 4-15
full-duplex ethernet 1-5
G
global warranty 1-13
groove, guiding 3-26
grounding
methods B-2
requirements 2-4
grouping feature 6-7
guidelines
SCSI cabling, external 7-6
server installation 4-1
guides
Compaq Concept Maintenance
and Service Guide 4-16
Compaq SmartStart Scripting
Toolkit User Guide 8-12
Important Safety
Information 4-2
guiding groove 3-26
H
hardware
options installation 3-1
troubleshooting problems after
adding 10-8
health driver 8-13
heat sink
removal 3-14
heat sink retaining clip
disengaging 3-14
engaging 3-18
heel straps B-2
hood latches 3-9
hot-plug power supplies
output power F-2
hot-spare boot 1-3
humidity, server F-2
hyperlink feature 6-7
I
IDE interface 1-6
identifying
DIMM sockets 3-19