Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide

Compaq Confidential – Need to Know Required
Writer: Ed Giblin Project: Compaq ProLiant DL360 Generation 2 Server Setup and Installation Guide Comments:
Part Number: 233832-001 File Name: o-appd Switches and Jumpers.doc Last Saved On: 8/31/01 11:46 AM
Appendix D
Switches and Jumpers
When a component is added or removed, or a security feature is changed, the
server must be reconfigured to recognize the changes. If the system
configuration is incorrect, the server may not work properly and error
messages may be displayed on the screen.
This appendix provides reference information about setting the system board
switches and jumpers, which is part of the reconfiguration process, along with
running the System Configuration Utility.
System Configuration Switches
The system board uses 3 DIP switches: (SW2) maintenance , (SW3) chassis
ID
and (SW4) miscellaneous support . Refer to the labels attached to the
inside of the server access panel or to the following table for the correct
system configuration switch settings. The following figure shows the location
of the system configuration switches.