HP ProLiant DL360 G6 Server MSG

Removal and replacement procedures 43
Heatsink
To remove the component:
1. Power down the server (on page 23).
2. Extend the server from the rack (on page 24).
3. Remove the access panel ("Access panel" on page 26).
4. Remove the BBWC battery pack, if installed ("BBWC battery pack" on page 35).
5. Remove the air baffle ("Air baffle" on page 36).
6. Remove the heatsink.
To replace the heatsink:
1. Use the alcohol swab to remove all the existing thermal grease from the processor. Allow the alcohol to
evaporate before continuing.
2. Apply new grease to the top of the processor in the following pattern to ensure even distribution.
CAUTION: The heatsink thermal interface media is not reusable and must be replaced if the
heatsink is removed from the processor after it has been installed.