HP ProLiant DL360 G6 Server MSG

Removal and replacement procedures 36
To replace the component, reverse the removal procedure.
Air baffle
To remove the component:
1. Power down the server (on page 23).
2. Extend the server from the rack (on page 24).
3. Remove the access panel ("Access panel" on page 26).
4. Remove the BBWC battery pack, if installed ("BBWC battery pack" on page 35).
5. Remove the air baffle.
To replace the component, reverse the removal procedure.
PCI riser board assembly
To remove the component:
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the PCI riser board assembly.
1. Power down the server (on page 23).
2. Extend the server from the rack (on page 24).
3. Remove the access panel ("Access panel" on page 26).
4. Remove the BBWC battery pack, if installed ("BBWC battery pack" on page 35).
5. Remove the air baffle ("Air baffle" on page 36).
6. Remove the PCI riser board assembly:
a. Disconnect external cables connected to any existing expansion boards.
b. Loosen the four PCI riser board assembly thumbscrews.