ProLiant DL360 Generation 4p Server (SAS Model) Maintenance and Service Guide

Removal and replacement procedures 13

Secure the server by tightening the thumbscrews.

6. Reconnect the peripheral cables and power cords.

Accessing the product rear panel

NOTE: To access some components, you may need to remove the cable management arm.

To open the arm:

To close the arm:

Removing the server from the rack

To remove the server from an HP, Compaq branded, telco, or third-party rack:

1. Power down the server ("Powering down the server" on page 11).

2. Disconnect all peripheral cables and power cords from the server rear panel.

3. Disconnect the cable management arm, if necessary. For more information, refer to the

documentation that ships with the cable management arm.