HP ProLiant DL360 Generation 4p Server Maintenance and Service Guide

Removal and replacement procedures 34

Remove the battery.

IMPORTANT: Replacing the system board battery resets the system ROM to its default configuration. After

replacing the battery, reconfigure the system through RBSU.

To replace the component, reverse the removal procedure.

For more information about battery replacement or proper disposal, contact an authorized reseller or an

authorized service provider.

System board

1. Power down the server (on page 12).

2. Extend or remove the server from the rack ("Extending the server from the rack" on page 12).

3. Remove the access panel ("Access panel" on page 14).

4. Remove the PCI riser board assembly ("PCI riser board assembly" on page 24).

CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all

AC power cords before removing or installing the expansion boards.

5. Remove the processor fan module ("Processor fan assembly" on page 22).

6. Remove the BBWCE ("Battery-Backed Write Cache Enabler" on page 28).

7. Remove any DIMMs ("DIMM" on page 30).

8. Remove the processors ("Processor" on page 31).

9. Disconnect all cables connected to the system board. For additional information, refer to "Server

Cabling (on page 36)."