HP ProLiant DL360 Generation 4p Server Maintenance and Service Guide

Removal and replacement procedures 23
9.
Slide the board toward the front edge of the server, lift up, then slide the board toward the rear of
the server to remove the component.
To replace the component, reverse the removal procedure.
SCSI backplane
1. Power down the server (on page 12).
2. Remove all hot-plug SCSI hard drives ("Hard drive" on page 16).
3. Extend or remove the server from the rack ("Extending the server from the rack" on page 12).
4. Remove the access panel ("Access panel" on page 14).
5. Remove the power supply fan module ("Processor fan assembly" on page 22).
6. Disconnect the cable from the optical device and diskette drive interface board.
7. Remove the component from the server.
To replace the component, reverse the removal procedure.