HP ProLiant DL360 Generation 4p Server Maintenance and Service Guide

Removal and replacement procedures 22
CAUTION: When replacing the component, be sure the power converter module is properly seated in the
server chassis.
To replace the component, reverse the removal procedure.
Processor fan assembly
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating
the server in this manner results in improper airflow and improper cooling that can lead to thermal damage.
To remove the component:
1. Extend or remove the server from the rack ("Extending the server from the rack" on page 12).
2. Remove the access panel ("Access panel" on page 14).
3. Loosen the thumbscrew that secures the processor fan assembly to the server.
4. Push on the sheet metal tab near the thumbscrew to separate the fan tray connector from the system
board connector.
5. Remove the component from the server.
To replace the component, reverse the removal procedure.
Optical device and diskette drive interface
1. Power down the server (on page 12).
2. Remove all hard drives and hard drive blanks ("Hard drive" on page 16).
3. Eject the optical device ("Optical device" on page 18).
4. Extend or remove the server from the rack ("Extending the server from the rack" on page 12).
5. Remove the access panel ("Access panel" on page 14).
6. Remove the diskette drive ("Diskette drive" on page 17).
7. Disconnect the cable from the optical device and diskette drive interface board.
8. Use a T-15 Torx screwdriver to remove the two screws securing the board to the server chassis.