HP ProLiant DL360 Generation 4p Server Maintenance and Service Guide

Removal and replacement procedures 19
IMPORTANT: The ejector button is recessed to prevent accidental ejection; it may be helpful to use a pen
or similar shaped object to access the button.
2. Press the ejector button.
3. Remove the optical device.
To replace the drive, slide the drive into the bay until it clicks.
Optical device ejector
1. Power down the server (on page 12).
2. Remove all hard drives ("Hard drive" on page 16) and the hard drive blank (on page 15).
3. Eject the optical device (on page 18) or optical device blank (on page 18).
4. Extend or remove the server from the rack ("Extending the server from the rack" on page 12).
5. Remove the diskette drive ("Diskette drive" on page 17).
6. Use a T-10 Torx screwdriver to remove the screws that secure the optical device ejector to the server
chassis.
7. Press the tab on the side of the optical device ejector to release it from the chassis.