ProLiant Server High-Density Deployment Server Solution

Modular PDU Power/Jumper Cords
Although PDUs and servers are typically shipped with power cords, the physical and electrical
requirements for a particular configuration may require different cords.
WARNING: Never cut or splice cords to accommodate a configuration.
Personal injury or equipment damage could result in the use of improper
power cords. The correct factory cord should always be used.
Table 2 Power and Jumper Cords
HP Part # Description
PDU Y- Cable kit 310782-B21 This kit includes 1 Y-cable that is 10-ft long with a 6-ft
section on the single-side and 4-ft sections on the dual-side.
10A IEC-to-IEC Cables
kit
142257-001 (6 ft)
142257-002 (8 ft)
142257-003 (10 ft)
142257-006 (4.5 ft)
142257-007 (4.5 ft)
15 each
The IEC-to-IEC cables can be used either as individual
power cords for the server or to extend the length of the
high-voltage Y-cables. The cables are available in 6-, 8-,
and 10-foot lengths. The HP ProLiant server ships with one
10-ft IEC-to-IEC cable, part number 142257-003.
Fixed Cord PDUs
Cable management and rack airflow are increasing concerns in any rack mount environment. The HP
Fixed Cord Extension Bars and Fixed Cord PDUs will significantly help you manage cable clutter in
the back of the rack, which will result in improved airflow through the rack. Designed exclusively for
1U fixed rail servers (DL360, DL320, and DL140), these PDUs offer the following new features that
are different from the modular PDUs:
• Output cords are attached to the PDU extension bar (stick), resulting in one less possible point of
accidental disconnect.
• Each output cord is only 33 cm (13 in) long, resulting in less obstruction to rack airflow and simpler
cable management.
• Seven (7) output cords per extension bar.
The Fixed Cord Extension Bars and Fixed Cord PDU are available in two configurations—either with
a modular PDU core and extension bar, or the extension bars only.
6