ProLiant DL360 Generation 2 Server Maintenance and Service Guide

Removal and Replacement Procedures
2-40 Compaq ProLiant DL360 Generation 2 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: Maisto Part Number: 233831-001 Last Saved On: 12/12/01 3:47 PM
System Board
To remove the system board:
1. Power down the server. See “Powering Down the Server” in this chapter.
2. Remove the server from the rack. See “Removing the Server from the Rack” in this
chapter.
3. Remove the access panel. See “Server Access Panel” in this chapter.
4. Remove the hot-plug SCSI hard drive(s). See “Hot-Plug SCSI Hard Drives” in this
chapter.
5. Remove the SCSI backplane. See “SCSI Backplane” in this chapter.
6. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” in this chapter.
7. Remove the air baffle. See “Air Baffle” in this chapter.
8. Remove the fan assembly. See “Fan Assembly” in this chapter.
9. Remove the AC power cord and filter. See “AC Power Cord and Filter” in this chapter.
10. Remove the power supply. See “Power Supply” in this chapter.
11. Disconnect the 80-pin connector from the system board. See “CD-ROM and Diskette
Drive Cable and Backplane” in this chapter.
12. Remove any SDRAM DIMMs. See “SDRAM DIMMs” in this chapter.
13. Remove the processor(s). See “Processors” in this chapter.
14. Remove the PPM(s). See “Processor Power Module” in this chapter.
15. Locate the alignment keys and keyhole locations
through on the system board.
4
3
2
1
5
6
7
8
9
Figure 2-35: Locating alignment keys and keyhole locations