ProLiant DL360 Generation 2 Server Maintenance and Service Guide

Removal and Replacement Procedures
Compaq ProLiant DL360 Generation 2 Server Maintenance and Service Guide 2-37
COMPAQ CONFIDENTIAL Codename: Maisto Part Number: 233831-001 Last Saved On: 12/12/01 3:47 PM
Processor Power Module
Each processor has an associated Processor Power Module (PPM). Figure 2-30 and Table 2-3
show the location of the processors and PPMs on the system board.
To remove a PPM:
1. Power down the server. See “Powering Down the Server” in this chapter.
2. Remove the server from the rack. See “Removing the Server from the Rack” in this
chapter.
3. Remove the access panel. See “Server Access Panel” in this chapter.
4. Open the PPM socket latches
.
5. Lift the PPM from the socket
.
2
1
1
Figure 2-32: Removing a PPM
Repeat steps 1 through 5 to replace a PPM.