ProLiant DL360 Generation 2 Server Maintenance and Service Guide

Removal and Replacement Procedures
2-30 Compaq ProLiant DL360 Generation 2 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: Maisto Part Number: 233831-001 Last Saved On: 12/12/01 3:47 PM
User Interface Board
To remove the user interface board:
1. Power down the server. See “Powering Down the Server” in this chapter.
2. Remove the server from the rack. See “Removing the Server from the Rack” in this
chapter.
3. Remove the access panel. See “Server Access Panel” in this chapter.
4. Remove the CD-ROM and diskette drives. See “Replacing the CD-ROM Drive” and
“Replacing the Floppy Drive” in this chapter for removal procedures.
5. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” in this chapter.
6. Remove the air baffle. See “Air Baffle” in this chapter.
7. Remove the AC power cord and filter. See “AC Power Cord and Filter” in this chapter.
8. Remove the power supply. See “Power Supply” in this chapter.
9. Remove the cable protector. See “Cable Protector” earlier in this chapter.
10. Remove the CD-ROM and diskette drive backplane. See “CD-ROM and Diskette Drive
Backplane” earlier in this chapter.
11. Slide the user interface board toward the rear of the server and lift to remove.
Figure 2-27: Removing the user interface board
Reverse steps 1 through 11 to replace the user interface board.