ProLiant DL360 Generation 2 Server Maintenance and Service Guide

Removal and Replacement Procedures
2-28 Compaq ProLiant DL360 Generation 2 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: Maisto Part Number: 233831-001 Last Saved On: 12/12/01 3:47 PM
CD-ROM and Diskette Drive Cable and Backplane
To remove the CD-ROM and diskette drive cable and backplane:
1. Power down the server. See “Powering Down the Server” in this chapter.
2. Remove the server from the rack. See “Removing the server from the Rack” in this
chapter.
3. Remove the access panel. See “Server Access Panel” in this chapter.
4. Remove the CD-ROM and diskette drives. See “Replacing the CD-ROM Drive” and
“Replacing the Floppy Drive” in this chapter for removal procedures.
5. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” in this chapter.
6. Remove the air baffle. See “Air Baffle” in this chapter.
7. Remove the AC power cord and line filter. See “AC Power Cord and Line Filter” in this
chapter.
8. Remove the power supply. See “Power Supply” in this chapter.
9. Remove the cable protector. See “Cable Protector” in this chapter.
10. Disconnect the 80-pin connector from the system board.
Figure 2-25: Disconnecting the 80-pin connector from the system
board