ProLiant DL360 Generation 2 Server Maintenance and Service Guide

Removal and Replacement Procedures
Compaq ProLiant DL360 Generation 2 Server Maintenance and Service Guide 2-27
COMPAQ CONFIDENTIAL Codename: Maisto Part Number: 233831-001 Last Saved On: 12/12/01 3:47 PM
Cable Protector
To remove the cable protector:
1. Complete the preparation procedures. See “Powering Down the Server” in this chapter.
2. Remove the server from the rack. See “Removing the Server from the Rack” in this
chapter.
3. Remove the access panel. See “Server Access Panel” in this chapter.
4. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” in this chapter.
5. Remove the air baffle. See “Air Baffle” in this chapter.
6. Remove the AC power cord and filter. See “AC Power Cord and Filter” in this chapter.
7. Remove the power supply. See “Power Supply” in this chapter.
8. Lift the front edge of the cable protector until it clears the CD ROM/Diskette backplane.
9. Pull the cable protector forward until it is free from its retaining slots. Lift the cable
protector from the server.
1
Figure 2-24: Removing the cable protector
Retaining slots
Reverse steps 1 through 9 to replace the cable protector.