ProLiant DL320 Setup and Installation Guide

Installing Hardware Options 3-37
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant DL320 Setup and Installation Guide Comments:
Part Number: 203836-001 File Name: d-ch3 Installing Hardware Options.doc Last Saved On: 8/23/00 4:00 PM
10. Repeat Steps 7 through 9 to install a second ATA hard drive.
11. Connect the ATA Device 0 Cable to your ATA Device 0 hard drive
and the ATA Device 1 Cable
to your ATA Device 1 hard drive.
1
2
Figure 3-31. Cabling your ATA hard drives (center wall and PCI riser board
assembly removed for clarity)
12. Connect the hard drive power cable to your ATA hard drives.
IMPORTANT: When connecting the power cable to your hard drives, ensure that the
connectors are installed with the red wire facing right (as viewed from the front of the
server).
13. Install the access panel. See “Installing the Access Panel” earlier in this
chapter.
14. Install the server in the rack. See “Inserting the Server into the Rack” in
Chapter 4, “Installing the Server.”
15. Power up the server. See “Powering up the Server” in Chapter 4,
“Installing the Server.”