ProLiant DL320 Setup and Installation Guide

Installing Hardware Options 3-33
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant DL320 Setup and Installation Guide Comments:
Part Number: 203836-001 File Name: d-ch3 Installing Hardware Options.doc Last Saved On: 8/23/00 4:00 PM
Hard Drive Identification Numbers
The ProLiant DL320 server standard configuration consists of two 1-inch hard
drive trays.
ATA hard drives installed in the ProLiant DL320 server appear as Devices 0
and 1, as shown in the following illustration.
IMPORTANT: Always populate hard drive bays starting with the lowest ATA Device
number or SCSI ID number.
NOTE: ATA hard drives are configured through the Cable-Select mode.
0
1
Figure 3-27. ATA device numbers or recommended SCSI ID numbers (drive
cables removed for clarity)