ProLiant DL320 Setup and Installation Guide

3-14 Compaq ProLiant DL320 Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant DL320 Setup and Installation Guide Comments:
Part Number: 203836-001 File Name: d-ch3 Installing Hardware Options.doc Last Saved On: 8/23/00 4:00 PM
Installing the Access Panel
After installing hardware options for your ProLiant DL320 server, replace the
server access panel. Use the following procedure to install the access panel:
1. Set the access panel on top of the server, aligning the sides of the
panel with the server and allowing the panel to extend past the rear of
the server approximately 0.5 inch (1.25 cm).
2. Slide the access panel toward the front of the unit about 0.5 inch
(1.25 cm). When the panel seats properly, the locking latches click
audibly into place.
1
2
Figure 3-12. Installing the access panel