ProLiant DL320 Setup and Installation Guide

Installing Hardware Options 3-9
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant DL320 Setup and Installation Guide Comments:
Part Number: 203836-001 File Name: d-ch3 Installing Hardware Options.doc Last Saved On: 8/23/00 4:00 PM
Removing the Center Wall
To install options that require modifications to cables between the front drive
area and the rear system area, you must remove the center wall. Before
removing this component, you must first remove the PCI riser board assembly.
Use the following procedure to remove the center wall.
1. Power down the server. See “Powering Down the Server” earlier in this
chapter.
2. Remove the access panel. See “Removing the Access Panel” earlier in
this chapter.
3. Remove the PCI Riser Board Assembly. See “Removing the
PCI Riser Board Assembly” earlier in this chapter.
4. Disconnect the center wall fan cables from the fan connectors on the
system board.
Figure 3-6. Disconnecting the center wall fan cables (processor removed for
clarity)