ProLiant DL320 Setup and Installation Guide

E-6 Compaq ProLiant DL320 Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant DL320 Setup and Installation Guide Comments:
Part Number: 203836-001 File Name: m-appe Troubleshooting.doc Last Saved On: 8/23/00 4:21 PM
Table E-4
The Front Panel Power On/Off LED is Amber.
CAUTION: Do not reseat the processor. Ignore any references to this operation in the Compaq
Servers Troubleshooting Guide. This operation is not supported for your server. When the
processor is reseated or its heatsink is removed, the thermal seal of the heatsink to the
processor is broken, the thermal effectiveness of the heatsink is compromised, and you must
replace the heatsink. For all issues regarding the processor, contact your Compaq authorized
service provider for assistance.
See “Front Panel LED Indicators” in Appendix D.
Possible Reasons The Next Step
The Power On/Off switch has not been
pressed.
A power supply problem may exist. The
power supply may have a damaged
connector, or may have failed.
The PCI riser board assembly may not be
properly seated.
Verify installation of the power supply and check all
connections.
If this does not solve the problem, contact your Compaq
authorized service provider for assistance.
Reseat the PCI riser assembly, and restart the server.
If this does not solve the problem, go to Question 2 in
Table E-1.