ProLiant DL320 Setup and Installation Guide

C-8 Compaq ProLiant DL320 Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant DL320 Setup and Installation Guide Comments:
Part Number: 203836-001 File Name: k-appc Server Error Messages.doc Last Saved On: 8/1/00 3:58 PM
Table C-1
POST Error Messages
continued
Error Code Audible Beeps Probable Source of
Problem
Action
1720-SMART Hard
Drive Detects
Imminent Failure
Your hard disk drive
is detecting an
imminent failure. To
prevent data loss,
back up the contents
of the disk, and
replace the hard
disk.
None A hard drive
predictive failure
condition has been
detected.
The indicated drive has reported a
SMART predictive failure condition.
It may fail at some time in the
future. If this drive is part of a
non-fault-tolerant configuration,
back up all data before replacing
the drive; then, restore all data. If
this drive is part of a fault-tolerant
configuration, do not replace this
drive unless all other drives in the
array are online. Press the F1 key
to resume.
1780-Disk 0 Failure
The drive is not
installed correctly or
has failed. Make
sure that any
jumpers are set
correctly, and that
power and drive
cables are
connected, both to
the drive and the
system board. Also
verify that the cables
are the correct
cables for your
computer model. If
this message
persists, your PC
may need to be
serviced.
None A hard drive/format
error has been
detected.
Run Compaq Diagnostics. Replace
failed assembly as instructed.
continued