ProLiant DL320 Setup and Installation Guide

C-6 Compaq ProLiant DL320 Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant DL320 Setup and Installation Guide Comments:
Part Number: 203836-001 File Name: k-appc Server Error Messages.doc Last Saved On: 8/1/00 3:58 PM
Table C-1
POST Error Messages
continued
Error Code Audible Beeps Probable Source of
Problem
Action
601-Diskette
Controller Error
The drive is not
installed correctly or
has failed. Make
sure that power and
drive cables are
connected, both to
the drive and the
system board. Also
verify that the cables
are the correct
cables for your
computer model. If
this message
persists, you may
need service for your
PC.
None CD-ROM/diskette
drive assembly is not
seated correctly. A
controller circuitry
failure occurred.
1. Verify that the
CD-ROM/diskette drive
assembly is properly inserted.
2. Make sure the cables are
attached to the backplane.
3. Replace the CD-ROM/diskette
drive assembly, the cable, the
backplane, or all three.
4. Research and replace the
failed assembly as instructed.
806-CMOS has been
reset
Please power off and
restore the clear
CMOS switch
(switch 2 on SW2)
None Switch 2 on SW2 has
been turned on, and
the system
configuration data
has been cleared
from CMOS. This
switch must be
returned to the
default off position
for normal operation
and to enable you to
save configuration
setup data.
The system must be
reconfigured.
1. Remove power from the
system.
2. Locate switch 2 on SW2.
See Appendix D for the
location of this switch.
3. Return switch 2 on SW2 to
the off position.
4. Restart the system.
5. Press F9 to run the server
setup utility and configure the
system.
6. Select the primary operating
system.
7. Set the date and time.
8. Complete additional
configuration as needed.
continued