ProLiant DL320 Setup and Installation Guide

C-4 Compaq ProLiant DL320 Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant DL320 Setup and Installation Guide Comments:
Part Number: 203836-001 File Name: k-appc Server Error Messages.doc Last Saved On: 8/1/00 3:58 PM
Table C-1
POST Error Messages
continued
Error Code Audible Beeps Probable Source of
Problem
Action
164-Memory Size
Error
The system memory
size is different from
the last startup. The
most common
reason is the
addition or removal
of memory to the
system board.
Pressing F1 will
record the
configuration. If this
message persists,
verify that the
memory modules are
installed correctly.
2 short Configuration
memory incorrect.
Run the server setup utility and
correct.
180-Log reinitialized
because length
check out of bounds
None The Integrated
Management Log
has been
reinitialized, probably
due to corruption of
the log.
Event message, no action required.
201-Memory Error
The memory test
performed during
startup failed.
Removing and
replacing memory
modules can isolate
the faulty memory.
Also verify that the
memory modules are
installed correctly.
None RAM failure
detected.
Run Compaq Diagnostics. Replace
failed assembly as instructed.
207-ECC Corrected
Single Bit Errors in
DIMM/SIMM PAIR(s)
in Memory Module
Socket(s) in Memory
Module DIMM
2 short A memory module is
malfunctioning.
Run Compaq Diagnostics. Replace
or remove malfunctioning memory
module as instructed.
continued