ProLiant DL320 Setup and Installation Guide

Server Configuration and Utilities 6-5
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant DL320 Setup and Installation Guide Comments:
Part Number: 203836-001 File Name: g-ch6 Server Configuration and Utilities.doc Last Saved On: 8/24/00 6:07 PM
MPS Table Mode allows the user to change the Application Program
Interface Controller (APIC) table setting. This setting should be automatically
set by the operating system selection, but Multiple Processor Specification
(MPS) table mode allows the user to override the automatic selection.
Post Speed Up allows the user to enable or disable the quick or slow start
process. The slow start process performs a complete memory test.
Automatic Server Recovery allows the user to enable or disable the
Automatic Server Recovery option.
Wake-On LAN (WOL) Support allows the user to enable or disable WOL
support.
Floppy Controller allows the user to enable or disable the floppy controller.
Processor Serial Number allows the user to enable or disable the ability of
applications to read the processor serial number.
NMI Debug Button allows the user to enable or disable the Nonmaskable
Interrupt (NMI) switch. This switch is located on the system board and is
disabled as the default setting.
Thermal Shutdown allows the user to disable or enable the ability of the
system to shutdown due to a thermal caution event. The default for this option
is enabled. Compaq does not recommend disabling this feature.
POST F1 Prompt allows the user to bypass the F1 prompt during the POST
test.
Preboot Execution Environment (PXE) Options are associated with the
user’s ability to download operating system configurations from the network
via the NIC 1 connector.
■ Embedded PXE Support allows the user to enable or disable the user’s
ability to remote boot from the network via the NIC 1 connector. The
default for this option is disabled.
■ User Interface allows the user to enable or disable the servers ability to
perform an unattended network boot via the NIC 1 connector. The
default for this option is enabled.
Set Default Configuration allows the user to reset the configuration settings
to their factory defaults.