ProLiant DL320 Server Maintenance and Service Guide

Connectors, Switches, and LED Indicators
4-6 Compaq ProLiant DL320 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: DarkStar-T Part Number: 203834-003 Last Saved On: 12/28/01 9:32 AM
System Switch (SW2)
The system switch (SW2) is a four-position switch used for performing recovery and other
diagnostic operations. Refer to the labels attached to the inside of the server access panel or
the following table for the proper system switch settings
CAUTION: Clearing CMOS or nonvolatile RAM (NVRAM) deletes your configuration
information. Refer to the Compaq ProLiant DL320 Server Setup and Installation Guide for
complete instructions on configuring your server.
Table 4-5: Switch Settings (SW2) Settings
Switch Position Function Default Position
S1 Clear password Off
S2 Clear CMOS Off
S3 Recovery mode Off
S4 Reserved Off
Note: “On” activates the function.
System Configuration Switch (SW3)
The system configuration switch (SW3) is an eight-position switch used for system
configuration. Refer to the labels attached to the inside of the server access panel or the
following table for the proper system configuration switch settings.
Table 4-6: System Configuration Switch (SW3) Settings
Switch Position Function Default Position
S1 VGA Disable Off
S2 Reserved Off
S3 Reserved Off
S4 Reserved Off
S5 Reserved Off
S6 Reserved Off
S7 Reserved Off
S8 Reserved Off
Note: “On” activates the function.