ProLiant DL320 Server Maintenance and Service Guide

Removal and Replacement Procedures
Compaq ProLiant 320 Server Maintenance and Service Guide 2-35
COMPAQ CONFIDENTIAL Codename: DarkStar-T Part Number: 203834-003 Last Saved On: 12/28/01 9:29 AM
Cables
The following sections contain removal and replacement procedures for the standard cables
that ship with the ProLiant DL320 server:
• Two-Device Terminated SCSI Cable
• ATA Cables
• CD-ROM (DVD-ROM)/Diskette Drive Assembly Cable
Two-Device Terminated SCSI Cable
To remove the SCSI cable:
1. Power down the server. See “Powering Down the Server” in this chapter.
2. Remove the access panel. See “Access Panel” in this chapter.
3. Remove the PCI riser board assembly. See “PCI Riser Board Assembly” in this chapter.
4. Remove the center wall. See “Center Wall” in this chapter.
CAUTION: To avoid hardware damage to the board, cable, or system board, use caution
when installing the SCSI module onto the support posts.
5. Disconnect the SCSI cable from the hard drives .
6. Disconnect the SCSI cable from the SCSI module
.
1
1
2
Figure 2-29: Disconnecting the SCSI cable
Reverse steps 1 through 5 to replace the SCSI cable.